More progress.

Making good progress now. The base portion has an extra layer of steel sheet attached to it – to set off the main sculptural form visually, and to allow for easy replacement in the event of damage. I drilled all the holes in the 3d model so their locations will be built right in to the cut sheet metal, plus it makes for easier documentation for the fabricators. (You can’t really make out the holes in this image, but there are 20 holes in the face we’re looking at here. Each penetrates through the outer gray layer, the yellow layer, and into the structural steel.)
W&P Base Skins

Leave a Reply

Your email address will not be published. Required fields are marked *